Parking Brake Cable - Subaru IMPREZA GD 2007 Series Manual

asieps_tobira_IM_US.book 5 ページ ２０１２年１月１７日 火曜日 午後３時４８分

3. Parking Brake Cable

A: REMOVAL
1) Lift up the vehicle.
2) Remove the rear wheels.
3) Remove the rear seat cushion.
4) Remove the console box.
5) Loosen the parking cable adjusting nut and con-
sole bracket.
6) Remove the parking brake lever.
7) Roll up the floor mat and remove the clamps.
8) Remove the equalizer cover.
9) Remove the inner cable end from equalizer.
(1) Equalizer
(2) Inner cable end
10) Remove the parking brake cable from rear
brake. <Ref. to PB-6, REMOVAL, Parking Brake
Assembly (Rear Disc Brake).>
11) Remove the clamp from the rear brake.
12) Remove the bolt and bracket from trailing link
bracket.
Parking Brake Cable
13) Remove the bolt and clamp from the rear floor.
14) Remove the grommet from the rear floor.
15) Remove the cable assembly from the cabin by
pulling it forcefully rearward.
16) Detach the parking brake cable from the cable
guide at the rear trailing link.
B: INSTALLATION
1) Install in the reverse order of removal.
NOTE:
PB-00074
Be sure to pass the cable through the tunnel in the
cable guide.
2) Be sure to adjust the lever stroke. <Ref. to PB-4,
ADJUSTMENT, Parking Brake Lever.>
C: INSPECTION
Check and replace the removed cable if damaged,
rusty or faulty.
1) Check the cable for smooth operation.
2) Check the inner cable for damage and rust.
3) Check the outer cable for damage, bends and
PB-00007
cracks.
4) Check the boot for damage, cracks, and corro-
sion.
PB-00008
PB-5
PARKING BRAKE
PB-00009