Subaru IMPREZA GD 2007 Series Manual page 2566

asieps_tobira_IM_US.book 59 ページ ２０１２年１月１７日 火曜日 午後３時４８分
18.Control Valve Body
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.
3) Lift up the vehicle.
4) Clean the transmission exterior.
5) Remove the drain plug and gasket, then drain
the ATF.
6) Replace the gasket with a new part and tighten
the drain plug.
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
7) Remove the oil pan.
NOTE:
Be sure to prevent the entering of dust and other
foreign matters into oil pan.
8) Remove the magnet.
9) Clean the magnet.
10) Completely remove the remaining liquid gasket
on the transmission case and oil pan.
Control Valve Body
11) Remove the control valve connector.
12) Remove the oil cooler pipe.
AT-02928
13) Remove the control valve body.
NOTE:
The control valve body is replaced as an assembly
only, because it is a non-disassembly part.
AT-02978
AT-02743
4AT-59
AUTOMATIC TRANSMISSION
AT-00058
AT-00059
AT-01717