Subaru IMPREZA GD 2007 Series Manual page 2886

asieps_tobira_IM_US.book 63 ページ ２０１２年１月１７日 火曜日 午後３時４８分
5) Install the 2nd driven gear, inner baulk ring, syn-
chro cone and outer baulk ring, and insert them
onto driven shaft.
(A) 2nd driven gear
(B) Inner baulk ring
(C) Synchro cone
(D) Outer baulk ring
6) After installing key on driven shaft, install the
3rd-4th driven gear using an ST and a press.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
NOTE:
Align the groove in baulk ring with the insert.
ST 499277200 INSTALLER
7) Install a set of roller bearings onto the driven
shaft using the ST and a press.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST 499277200 INSTALLER
Drive Pinion Shaft Assembly
(D) (A)
(B) (C)
MT-01329
ST
MT-00255
ST
MT-00256
5MT-63
MANUAL TRANSMISSION AND DIFFERENTIAL
8) Position the woodruff key in groove of the rear of
driven shaft. Install the 5th driven gear onto driven
shaft using ST and a press.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST 499277200 INSTALLER
9) Install the lock washer. Install the lock nut and
tighten to the specified torque using the ST.
ST 499987300 SOCKET WRENCH (50)
Tightening torque:
260 N·m (26.5 kgf-m, 191.7 ft-lb)
NOTE:
• Crimp the locknut in 2 locations.
• Using a spring scale, check that starting torque
of roller bearing is 0.1 to 1.5 N (0.01 to 0.15 kgf,
0.02 to 0.33 lbf).
ST
MT-00257
ST
MT-00258
MT-00259