asieps_tobira_IM_US.book 57 ページ 2012年1月17日 火曜日 午後3時48分
Diagnostic Procedure with Diagnostic Trouble Code (DTC)
Step
1
CHECK DTC.
2
CHECK HARNESS BETWEEN DRIVER'S
CONTROL CENTER DIFFERENTIAL CON-
TROL MODULE AND ACCELERATOR PED-
AL POSITION SENSOR.
1) Turn the ignition switch to OFF.
2) Disconnect the harness connectors of the
driver's control center differential control mod-
ule, ECM, and accelerator pedal position sen-
sor.
3) Measure resistance of the harness between
driver's control center differential control mod-
ule harness connector and the accelerator
pedal position sensor harness connector.
Connector & terminal
(B380) No. 2 — (B135) No. 2:
3
CHECK HARNESS BETWEEN DRIVER'S
CONTROL CENTER DIFFERENTIAL CON-
TROL MODULE AND ECM.
Measure resistance between the driver's con-
trol center differential control module harness
connector and the ECM harness connector.
Connector & terminal
(B380) No. 2 — (B136) No. 28:
4
CHECK HARNESS BETWEEN DRIVER'S
CONTROL CENTER DIFFERENTIAL CON-
TROL MODULE AND ACCELERATOR PED-
AL POSITION SENSOR.
Measure resistance of the harness between the
driver's control center differential control mod-
ule harness connector and the chassis ground
Connector & terminal
(B380) No. 2 — Chassis ground:
5
CHECK DRIVER'S CONTROL CENTER DIF-
FERENTIAL CONTROL MODULE INPUT
SIGNAL.
1) Connect all the connectors.
2) Connect the Subaru Select Monitor to the
data link connector.
3) Turn the ignition switch and run the Subaru
Select Monitor.
4) Read the data of "sub accelerator sensor
voltage" using the Subaru Select Monitor.
Check whether the data is within the specifica-
tion when the accelerator pedal is not pressed.
MANUAL TRANSMISSION AND DIFFERENTIAL (DIAGNOSTICS)
Check
Is a DTC displayed in the
engine self diagnosis test
mode?
Is the resistance less than 1 Ω? Go to step 3.
Is the resistance less than 1 Ω? Go to step 4.
Is the resistance 1 MΩ or
more?
Does the data read 0.1 — 1.3
V?
6MT(diag)-57
Yes
No
Refer to the sec-
Go to step 2.
tion on engine
DTCs, and perform
inspection. <Ref.
to
EN(H4DOTC)(diag
)-76, LIST, List of
Diagnostic Trouble
Code (DTC).>
Repair the harness
open circuit
between the
driver's control
center differential
control module and
the accelerator
pedal position sen-
sor.
Repair the harness
open circuit
between the
driver's control
center differential
control module and
the ECM.
Go to step 5.
Repair the short
circuit of the har-
ness between the
driver's control
center differential
control module,
accelerator pedal
position sensor,
and ECM.
Go to step 6.
Go to step 7.