Subaru IMPREZA GD 2007 Series Manual page 3344

asieps_tobira_IM_US.book 20 ページ ２０１２年１月１７日 火曜日 午後３時４８分
DRIVE SHAFT SYSTEM
8) Install the disc rotor to hub.
9) Install the disc brake caliper on the housing.
Tightening torque:
Except for STI model
80 N·m (8.2 kgf-m, 59 ft-lb)
STI model
155 N·m (15.8 kgf-m, 114.3 ft-lb)
10) Connect the stabilizer link.
Tightening torque:
Except for STI model
30 N·m (3.1 kgf-m, 22 ft-lb)
STI model
45 N·m (4.6 kgf-m, 33 ft-lb)
CAUTION:
Be sure to use a new self-locking nut.
11) Using ST1 and ST2, pull the front drive shaft
into the required position.
ST1 922431000 AXLE SHAFT INSTALLER
ST2 927390000 ADAPTER
ST
12) While depressing the brake pedal, tighten a
new axle nut to the specified torque and lock it se-
curely.
Tightening torque:
220 N·m (22.4 kgf-m, 162 ft-lb)
CAUTION:
Do not overtighten it as this may damage the
wheel bearing.
13) After tightening the axle nut, lock it securely.
14) Install the ABS wheel speed sensor on the
housing.
Tightening torque:
33 N·m (3.4 kgf-m, 24 ft-lb)
Front Axle
15) Install the wheel and tighten the wheel nuts to
specified torque.
Tightening torque:
100 N·m (10.2 kgf-m, 73.8 ft-lb)
C: DISASSEMBLY
1. EXCEPT FOR STI MODEL
1) Using ST1, securely support the housing and
hub.
2) Attach ST2 to housing and drive hub out.
ST1 927060000 HUB REMOVER
ST2 927080000
DS-00104
NOTE:
• If inner bearing race remains in the hub, remove
it with a suitable tool (commercially available tools).
• Be careful not to scratch the polished area of the
hub.
DS-00048
CAUTION:
If the hub is removed, the bearing cannot be re-
used.
DS-20
HUB STAND
ST1
ST2
ST1
ST2
DS-00049
DS-00050