Subaru IMPREZA GD 2007 Series Manual page 2549

asieps_tobira_IM_US.book 42 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
32) Install the ATF level gauge.
33) Connect the following connectors.
(1) Transmission harness connectors
(2) Transmission ground terminal
34) Install the air intake chamber stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.8 ft-lb)
35) Install the air intake chamber and intake duct.
(Non-turbo model) <Ref. to IN(H4SO)-6, INSTAL-
LATION, Air Intake Chamber.>
36) Install the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-14, INSTALLATION, Intercooler.>
37) Connect the ground cable to the battery.
38) Using the oil charge pipe, fill with ATF until the
fluid level is between the upper and lower level on
the "COLD" side of the level gauge. <Ref. to 4AT-
28, Automatic Transmission Fluid.>
39) Lower the vehicle from the lift.
40) Check the select lever operation. <Ref. to 4AT-
47, INSPECTION, Inhibitor Switch.>
41) Bleed the air from the control valve body. <Ref.
to 4AT-62, PROCEDURE, Air Bleeding of Control
Valve.>
42) Check the ATF level. <Ref. to 4AT-28, Auto-
matic Transmission Fluid.>
43) Execute learning control promotion. <Ref. to
4AT(D)(diag)-16, FACILITATION OF LEARNING
CONTROL, OPERATION, Subaru Select Moni-
tor.>
44) Perform the road test. <Ref. to 4AT-31, Road
Test.>
Automatic Transmission Assembly
AT-00693
4AT-42