Subaru IMPREZA GD 2007 Series Manual page 3367

asieps_tobira_IM_US.book 43 ページ ２０１２年１月１７日 火曜日 午後３時４８分
5) Install the DOJ inner race on shaft and fix the
snap ring in place with pliers.
NOTE:
Confirm that the snap ring is completely fitted in the
shaft groove.
6) Install the removed cage, to the inner race fixed
onto the shaft.
NOTE:
Fit the cage with the protruding section aligned with
the track on the inner race, and turn by a half pitch.
(A)
(A) Inner race
(B) Cage
7) Fill 80 to 90 g (2.82 to 3.17 oz) of specified
grease into the inner side of the DOJ outer race.
8) Apply a thin coat of specified grease to the cage
pocket and six ball bearings.
9) Insert the six ball bearings into the cage pocket.
10) Align the outer race track and ball positions, and
place the shaft, inner race, cage and ball bearings in
the original positions, and then fix outer race in place.
(A) Outer race
(B) Grease
Rear Drive Shaft
DS-00128
(B)
DS-00129
(A)
(B)
DS-00126
DS-43
11) Install the snap ring in the groove on the DOJ
outer race.
NOTE:
• Assure that the balls, cage and inner race are
completely fitted in the outer race of DOJ.
• Use care not to place the matched position of
snap ring in the ball groove of outer race.
• Pull the shaft lightly and assure that the circlip is
completely fitted in the groove.
12) Apply an even coat of the specified grease [20
to 30 g (0.71 to 1.06 oz)] to the entire inner surface
of boot. Also apply grease to the shaft.
13) Install the DOJ boot taking care not to twist it.
NOTE:
• The inside of the larger end of DOJ boot and the
boot groove shall be cleaned so as to be free from
grease and other substances.
• When installing the DOJ boot, position the outer
race of DOJ at center of the stroke.
14) Put a new band through the clip and wind twice
in the band groove of the boot.
NOTE:
When tightening boot, use care so that the air with-
in the boot is appropriate.
15) Tighten the band using the ST.
ST 925091000 BAND TIGHTENING TOOL
NOTE:
Tighten the band until it cannot be moved by hand.
DRIVE SHAFT SYSTEM
DS-00125
DS-00284