Subaru IMPREZA GD 2007 Series Manual page 2990

asieps_tobira_IM_US.book 85 ページ ２０１２年１月１７日 火曜日 午後３時４８分
11) Attach the 1st-2nd sleeve to the 1st-2nd hub.
NOTE:
Make sure that the 1st-2nd sleeve is installed in the
correct direction.
(A) 1st driven gear
(B) 1st-2nd sleeve
(C) 1st driven gear side
12) Install the outer baulk ring.
13) Install the 2nd synchro cone.
Driven Gear Assembly
(B)
(A)
(B)
(C)
MT-00603
MT-00604
MT-01506
6MT-85
MANUAL TRANSMISSION AND DIFFERENTIAL
14) Install the inner baulk ring.
15) Apply adequate gear oil to the bushing, 2nd
needle bearing and 2nd drive gear inner surface.
16) Install the 2nd needle bearing and 2nd driven
gear.
NOTE:
Match the protrusion of the 2nd synchro cone to the
hole of the 2nd driven gear, then install.
(B)
(C)
(A) 2nd needle bearing
(B) 2nd driven gear
(C) Protrusion of the 2nd synchro cone
17) Attach the key.
MT-00606
(A)
MT-00607
MT-00608