Subaru IMPREZA GD 2007 Series Manual page 2753

asieps_tobira_IM_US.book 20 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CLUTCH SYSTEM
5) Tighten the plug.
Tightening torque:
48 N·m (4.9 kgf-m, 35.4 ft-lb)
6) Check the bearing for smooth movement by op-
erating the release lever.
7) Install the transmission assembly.
<Ref. to 6MT-36, INSTALLATION, Manual Trans-
mission Assembly.>
C: INSPECTION
1. RELEASE BEARING
CAUTION:
Since this bearing is grease-sealed and is a
non-lubrication type, do not wash with gasoline
or any other solvent when servicing the clutch.
1) Check the bearing for smooth movement by ap-
plying force to the bearing in the radial direction.
Radial direction stroke:
5MT non-turbo model
1.4 mm (0.055 in)
5MT turbo model
1.6 mm (0.063 in)
(A)
(A) Bearing case
Release Bearing and Lever
6MT model
1.6 mm (0.063 in)
CL-00031
2) While applying force to the bearing in the rota-
tional direction, check the bearing for smooth rota-
tion.
3) Check for wear and damage at the bearing case
surface in contact with the lever.
2. RELEASE LEVER
Check the pivot portion of the lever and the contact
area with the release bearing case for wear.
CL-00032
CL-20
(A)
(A) Bearing case
(A)
(A) Bearing case
(A)
(B)
(C)
(A) Release lever
(B) Pivot
(C) Release bearing
CL-00527
CL-00160
CL-00034