Subaru IMPREZA GD 2007 Series Manual page 2547

asieps_tobira_IM_US.book 40 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
(2) Connect the transmission and the engine.
(3) While raising the transmission jack gradual-
ly, turn the screw of engine support, and tilt the
engine forward.
5) Install the transmission rear crossmember.
Tightening torque:
T1: 35 N·m (3.6 kgf-m, 26 ft-lb)
T2: 70 N·m (7.1 kgf-m, 51.6 ft-lb)
T 2
6) Remove the transmission jack.
7) Tighten the bolts which hold the lower side of the
transmission to the engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
8) Tighten the bolt of the clutch housing cover.
9) Lower the lift.
10) Connect the engine and transmission.
(1) Remove the ST from converter case.
NOTE:
When removing the ST, be careful not to drop it into
converter case.
ST 498277200 STOPPER SET
(2) Install the starter. <Ref. to SC(H4SO)-8, IN-
STALLATION, Starter.>
(3) Tighten the bolts which hold the upper side
of the transmission to the engine.
Automatic Transmission Assembly
T 1
T 2
AT-03698
AT-00108
4AT-40
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
11) Install the torque converter clutch to drive plate.
CAUTION:
• Be careful not to damage the mounting bolts.
• Be careful not to drop bolts into the converter
case.
(1) Tighten the bolts which hold the torque con-
verter clutch to the drive plate.
(2) While rotating the crank pulley in the direc-
tion of engine rotation a little bit at a time, tight-
en all bolts.
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
(3) Fit the plug to service hole.
(4) Install the V-belt cover.
12) Remove the ST.
ST 41099AC000 ENGINE SUPPORT ASSY
13) Install the pitching stopper bracket.
Tightening torque:
41 N·m (4.2 kgf-m, 30.2 ft-lb)
AT-00106
AT-00102
ST
AT-02984