Subaru IMPREZA GD 2007 Series Manual page 3022

asieps_tobira_IM_US.book 117 ページ ２０１２年１月１７日 火曜日 午後３時４８分
4) According to both of the measurements, calcu-
late the neutral position of the 3rd-4th sleeve. From
the following calculation, select a fork rod which
matches the calculated value.
Calculation: T = (C1 + C2) / 2
T: 3rd-4th sleeve center position
C1: Measured depth from the main shaft rear bear-
ing snap ring groove to the sleeve end, when shift-
ed to 3rd gear: +55 mm (2.17 in)
C2: Measured depth from the main shaft rear bear-
ing snap ring groove to the sleeve end, when shift-
ed to 4th gear
NOTE:
Attach the indicator upside down in comparison to
the setting procedures for the zero point. Add "d1"
[Value: 55 mm (2.17 in)] from the figure below to
"C1", and measure "C1".
d1
M.SFT
Snap ring
T mm (in)
805072010
[t = 1.65 mm
(0.065 in)]
137.22 —
137.52 32809AA171
(5.4024 — (none)
5.4142)
137.52 —
137.82 32809AA161
(5.4142 — (1)
5.4260)
137.82 —
138.12 32809AA141
(5.4260 — (3)
5.4379)
T = Thickness
Shifter Fork and Rod
MT-00705
Lot No. (marking)
M.SFT M.SFT
Snap ring Snap ring
805072011 805072012
[t = 1.95 mm [t = 2.25 mm
(0.077 in)] (0.089 in)]
32809AA181 32809AA191
(2) (4)
32809AA171 32809AA181
(none) (2)
32809AA161 32809AA171
(1) (none)
6MT-117
MANUAL TRANSMISSION AND DIFFERENTIAL
3. 5TH-6TH FORK ROD SELECTION
NOTE:
In the following conditions, perform the procedures
below.
• Main shaft replacement
• 3rd to 6th drive gear and bushing replacement
• 3rd to 6th synchro ring assembly replacement
• 3rd-4th hub and sleeve assembly replacement
• 5th-6th hub and sleeve assembly replacement
1) Insert the main shaft assembly into the adapter
plate.
2) Set the height gauge to the adapter plate. Lower
the height gauge indicator to the upper face of the
snap ring groove or the upper side of the main rear
bearing. Set to zero point.
ST 18853AA000 HEIGHT GAUGE
(A) Ball bearing
NOTE:
• The height gauge will be set on the adapter plate
during the measurement. Use a scraper to remove
any gasket material remaining on the end face.
• During measurement, do not place the height
gauge in the shaded area shown in the figure.
(A)
MT-00706
MT-00583