Subaru IMPREZA GD 2007 Series Manual page 3024

asieps_tobira_IM_US.book 119 ページ ２０１２年１月１７日 火曜日 午後３時４８分
(3) Shift the 5th-6th sleeve to the 5th main gear
side, push down to the stopper, and measure
"D1".
(A) 5th main gear
NOTE:
• Set the height gauge indicator near the measure-
ment target, and lock dial (1) as shown in the figure.
Turn dial (2), and set the indicator to the 5th side
end surface of the sleeve.
• Turn approximately 72° at a time, and measure
the sleeve in 5 locations. Round off the two highest
and two lowest measurement values. The remain-
ing center value is used as the measurement value.
4) According to both of the measurements, calcu-
late the neutral position of the 5th-6th sleeve. From
the following calculation, select a fork rod which
matches the calculated value.
Calculation: T = (D1 + D2) / 2
T: 5th-6th sleeve center position
D1: Measured length from the shaft rear bearing
snap ring groove to the sleeve groove end, when
shifted to 5th gear [Value: +55 mm (2.17 in)]
D2: Measured length from the main shaft rear bear-
ing snap ring groove to the sleeve groove end,
when shifted to 6th gear
Shifter Fork and Rod
NOTE:
Attach the indicator upside down in comparison to
the setting procedures for the zero point. Add "d1"
[Value: 55 mm (2.17 in)] from the figure below to
"D1", and measure "D1".
(A)
MT-00714
(2)
(1)
MT-00585
6MT-119
MANUAL TRANSMISSION AND DIFFERENTIAL
d1
Lot No. (marking)
M.SFT
Snap ring Snap ring
T mm (in)
805072010 805072011
[t = 1.65 mm [t = 1.95 mm
(0.065 in)] (0.077 in)]
64.12 —
64.42 32945AA021 32945AA031
(2.5244 — (none)
2.5362)
64.42 —
64.72 32945AA011 32945AA021
(2.5362 — (1)
2.5480)
64.72 —
65.02 32945AA001 32945AA011
(2.5480 — (3)
2.5598)
T = Thickness
MT-00705
M.SFT M.SFT
Snap ring
805072012
[t = 2.25 mm
(0.089 in)]
32945AA041
(2) (4)
32945AA031
(none) (2)
32945AA021
(1) (none)