Subaru IMPREZA GD 2007 Series Manual page 2548

asieps_tobira_IM_US.book 41 ページ ２０１２年１月１７日 火曜日 午後３時４８分
14) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
T2
15) Install the throttle body. <Ref. to FU(H4SO)-12,
INSTALLATION, Throttle
FU(H4DOTC)-16, INSTALLATION,
Body.>
16) Lift up the vehicle.
17) Replace the circlip of the front drive shaft with a
new part.
18) Apply grease to the oil seal lip.
19) Attach the ST to side retainer.
ST 28399SA010 OIL SEAL PROTECTOR
ST
20) Align and insert the spline of the front drive
shaft to the splines of the differential bevel gear,
and remove the ST.
ST 28399SA010 OIL SEAL PROTECTOR
21) Insert the front drive shaft into the transmission
securely by pressing the front housing from the out-
side.
22) Install the ball joint into the housing.
Automatic Transmission Assembly
23) Connect the stabilizer link to the transverse
link, and tighten the bolts.
NOTE:
Use a new self-locking nut.
Tightening torque:
T1
AT-00691
Body.> <Ref. to
Throttle
24) Install the shift select cable onto select lever.
<Ref. to CS-27, INSTALLATION, Select Cable.>
25) Install the oil charge pipe, and connect the ATF
cooler hoses to the pipe.
26) Install the propeller shaft. <Ref. to DS-16, IN-
STALLATION, Propeller Shaft.>
AT-00110
27) Install the rear exhaust pipe and muffler as-
sembly.
Non-turbo model
<Ref. to EX(H4SO)-8, INSTALLATION, Rear Ex-
haust Pipe.> <Ref. to EX(H4SO)-9, INSTALLA-
TION, Muffler.>
Turbo model
<Ref. to EX(H4DOTC)-15, INSTALLATION, Rear
Exhaust Pipe.> <Ref. to EX(H4DOTC)-17, IN-
STALLATION, Muffler.>
28) Install the front and center exhaust pipe. (Non-
turbo model) <Ref. to EX(H4SO)-5, INSTALLA-
TION, Front Exhaust Pipe.>
29) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(H4DOTC)-11, INSTALLATION, Center
Exhaust Pipe.>
30) Install the under cover.
31) Lower the lift.
AT-00111
4AT-41
AUTOMATIC TRANSMISSION
T1: 30 N·m (3.1 kgf-m, 22.1 ft-lb)
T2: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T1
T2
AT-00692
AT-01333