Subaru IMPREZA GD 2007 Series Manual page 2474

asieps_tobira_IM_US.book 73 ページ ２０１２年１月１７日 火曜日 午後３時４８分
28) Draw out the piston pin from #1 and #2 pistons
using ST.
NOTE:
Be careful not to confuse the original combination
of piston, piston pin and cylinder.
ST 499097700 PISTON PIN REMOVER
(6)
(5)
(1) Cylinder block
(2) Rear oil seal
(3) Crankshaft
34) Remove the rear oil seal.
35) Remove the crankshaft together with connect-
ing rod.
36) Remove the crankshaft bearings from cylinder
block using a hammer handle.
NOTE:
Be careful not to confuse the crankshaft bearing
combination. Press the bearing at the end opposite
to locking lip.
Cylinder Block
29) Similarly remove the piston pins from #3 and #4
pistons.
30) Remove the cylinder block connecting bolt on
the RH side.
31) Loosen the cylinder block connecting bolt on
the LH side by 2-3 turns.
32) Set the part so that the cylinder block (LH) is on
the upper side, and remove the cylinder block con-
necting bolt.
33) Separate the cylinder block (LH) and (RH).
ST
NOTE:
When separating the cylinder block, do not allow
the connecting rod to fall and damage the cylinder
block.
ME-00142
(7)
(6)
(1)
(4)
(3)
(4) Crankshaft bearing
(5) Piston
37) Draw out each piston from cylinder block using
wooden bar or hammer handle.
NOTE:
Be careful not to confuse the original combination
of piston and cylinder.
ME(H4DOTC)-73
(2)
(4)
(1)
(5)
(6) Seal washer
(7) Washer
MECHANICAL
ME-02881