Subaru IMPREZA GD 2007 Series Manual page 2847

asieps_tobira_IM_US.book 24 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
2. Transmission Gear Oil
A: INSPECTION
1) Park the vehicle on a level surface.
2) Turn the ignition switch to OFF, and wait until the
engine cools.
3) Remove the oil level gauge and wipe it clean.
4) Reinsert the level gauge all the way. Be sure that
the level gauge is correctly inserted in the proper
direction.
5) Pull out the oil level gauge again, and check the
oil level. If it is lower level or less, add oil through
the oil level gauge hole to bring the level up to the
upper level.
(A)
(A) Oil level gauge
(B) Upper level
(C) Lower level
B: REPLACEMENT
1) Pull out the oil level gauge.
2) Lift up the vehicle.
®
3) Using the TORX bit T70, remove the drain
plug, and drain the transmission gear oil complete-
ly.
CAUTION:
• Immediately after the engine has been run-
ning, the transmission gear oil is hot. Be careful
not to burn yourself.
• Be careful not to spill the transmission gear
oil on the exhaust pipe, to prevent emission of
smoke or causing a fire. If differential gear oil is
spilled on the exhaust pipe, wipe it off com-
pletely.
Transmission Gear Oil
4) Using the TORX
sion gear oil drain plug.
NOTE:
• Tighten the drain plug of the transmission gear
oil after draining the transmission gear oil.
• Use a new gasket.
Tightening torque:
44 N·m (4.5 kgf-m, 32.5 ft-lb) (Aluminum gas-
ket)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (Copper gasket)
(B)
(C)
5) Lower the vehicle.
6) Pour gear oil through the gauge hole.
PM-00030
Recommended gear oil:
GL-5 (75W-90) or equivalent
Gear oil capacity:
3.5 (3.7 US qt, 3.1 Imp qt)
2
7) Measure the transmission gear oil level to check
that it is within specifications.
CAUTION:
When inserting the level gauge into transmis-
sion, align the protrusion on the top part of the
level gauge with the notch in the gauge hole.
5MT-24
®
bit T70, tighten the transmis-
MT-01548