Subaru IMPREZA GD 2007 Series Manual page 3018

asieps_tobira_IM_US.book 113 ページ ２０１２年１月１７日 火曜日 午後３時４８分
F: ADJUSTMENT
1. 1ST-2ND FORK ROD SELECTION
NOTE:
In the following conditions, perform the procedures
below.
• Replacement of the 1st and 2nd driven gear
• 1st and 2nd synchro ring assembly replacement
• Adapter plate replacement
• Driven shaft replacement
• 1st-2nd hub and sleeve assembly replacement.
1) Insert the drive pinion assembly into the adapter
plate.
NOTE:
Confirm that the thrust bearing outer race has not
been removed and the drive pinion is not lifted.
2) Set the height gauge to the adapter plate. Lower
the height gauge indicator to the mating surface of
the adapter plate and case, and set to zero points.
ST 18853AA000 HEIGHT GAUGE
ST
NOTE:
• The adapter plate will be the base point for the
measurement. Use a scraper to remove any gasket
material remaining on the end face.
• During measurement, do not place the height
gauge in the shaded area shown in the figure.
3) Select the main shaft snap ring. <Ref. to 6MT-
79, ADJUSTMENT, Main Shaft Assembly.>
Shifter Fork and Rod
MANUAL TRANSMISSION AND DIFFERENTIAL
4) Measure "B1" and "B2" as shown in the figure.
(1) Shift the 1st-2nd sleeve to the 1st driven
gear side, push down to the stopper, and mea-
sure "B1".
(A) 1st driven gear
(B) 1st-2nd sleeve
NOTE:
• Set the height gauge indicator near the measure-
MT-00582
ment target, and lock dial (1) as shown in the figure.
Turn dial (2), and set the indicator to the 1st side
end surface of the sleeve.
• Turn approximately 72° at a time, and measure
the sleeve in 5 locations. Round off the two highest
and two lowest measurement values. The remain-
ing center value is used as the measurement value.
MT-00583
6MT-113
B2
B1
MT-00979
(B)
(A)
MT-00702
(2)
(1)
MT-00585