Subaru IMPREZA GD 2007 Series Manual page 2992

asieps_tobira_IM_US.book 87 ページ ２０１２年１月１７日 火曜日 午後３時４８分
25) Attach ST3 to the lock nut, attach ST to the driv-
en gear assembly, and tighten the lock nut.
ST1 18666AA000 HOLDER
ST2 18664AA000 BASE
ST3 18620AA000 ADAPTER WRENCH
ST4 18852AA000 TORQUE WRENCH
Tightening torque:
530 N·m (54.0 kgf-m, 391 ft-lb)
ST3
NOTE:
When using a torque wrench other than ST4, use
the calculation below to calculate and tighten the
lock nut.
T = L1/(0.1 + L1) × 570
T N·m (kgf-m, ft-lb) Torque wrench setting
L1 m (in) Torque wrench length
0.1 m (3.94 in)
570 N·m (58.1 kgf-m, 420 ft-lb)
(A)
(A) 0.1 m (3.94 in)
Driven Gear Assembly
ST4
ST2
ST1
MT-00613
Length of ST
Tightening torque
(lock nut):
L1
MT-00614
6MT-87
MANUAL TRANSMISSION AND DIFFERENTIAL
26) Using the ST, crimp the lock nut in 4 locations,
with dimensions within A 44±0.5 mm (1.73±0.02
in).
ST 18669AA000 PUNCH
NOTE:
Do not damage the crimp area of the lock nut.
ST
A
A
MT-00615