asieps_tobira_IM_US.book 23 ページ 2012年1月17日 火曜日 午後3時48分
3. Select Lever
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from the battery.
3) Set the select lever to "N" range.
4) Lift up the vehicle.
5) Remove the rear exhaust pipe and muffler.
• SOHC model
<Ref. to EX(H4SO)-8, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H4SO)-9, REMOVAL, Muffler.>
• DOHC Turbo model
<Ref. to EX(H4DOTC)-15, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-17, REMOV-
AL, Muffler.>
6) Disconnect the cable from select lever and then
remove the cable bracket.
( B )
(A) Adjusting nut
(B) Cable bracket
7) Lower the lift.
8) Remove the console box. <Ref. to EI-46, RE-
MOVAL, Console Box.>
9) Disconnect the connectors, and then remove the
four bolts to take out the select lever from vehicle
body.
Select Lever
B: INSTALLATION
1) Set the select lever to vehicle body.
2) Tighten the four bolts to install the select lever to
vehicle body, and then connect the connector.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
3) Install the console box. <Ref. to EI-46, INSTAL-
LATION, Console Box.>
4) Set the select lever to "N" range.
5) Lift up the vehicle.
6) Set the select lever to "N" range.
7) Insert the tip of inner cable into connector hole of
the select lever, and affix the outer cable end to the
bracket.
Tightening torque:
( A )
CS-00017
18 N·m (1.8 kgf-m, 13.0 ft-lb)
8) Adjust the select cable position. <Ref. to CS-28,
ADJUSTMENT, Select Cable.>
9) After the completion of adjustment, confirm that
the select lever operates properly at all range posi-
tions.
10) Install the rear exhaust pipe and muffler.
• SOHC model
<Ref. to EX(H4SO)-8, INSTALLATION, Rear Ex-
haust Pipe.> <Ref. to EX(H4SO)-9, INSTALLA-
TION, Muffler.>
• DOHC Turbo model
<Ref. to EX(H4DOTC)-15, INSTALLATION, Rear
Exhaust Pipe.> <Ref. to EX(H4DOTC)-17, IN-
STALLATION, Muffler.>
11) Inspect the following items. When a malfunc-
tion is found in the inspection, adjust the select ca-
ble
ADJUSTMENT, Select Cable.> <Ref. to 4AT-47,
ADJUSTMENT, Inhibitor Switch.>
CS-00018
(1) Engine starts when the select lever is in "P"
and "N" range, but not in other ranges.
(2) Back-up light illuminates when the select le-
ver is in the "R" range, but not in other ranges.
(3) Select lever and indicator positions are
matched.
CS-23
CONTROL SYSTEMS
and
inhibitor
switch.
<Ref.
CS-00019
to
CS-28,