Subaru IMPREZA GD 2007 Series Manual page 2820

asieps_tobira_IM_US.book 47 ページ ２０１２年１月１７日 火曜日 午後３時４８分
14) Pull out the reverse check cable from under-
side of the vehicle to remove it.
NOTE:
Be careful not to damage the inner boot.
15) Loosen the locknut, and remove the reverse
check cable from the cable plate.
(B)
(A) Cable plate
(B) Reverse check cable
B: INSTALLATION
1) Insert the reverse check cable into the inner boot
hole from underside of the vehicle.
2) Using the spring pin, fix the end of reverse check
cable and slider.
NOTE:
Apply grease to the moving part of slider.
(A)
(A) Slider
(B) Spring pin
Reverse Check Cable
(A)
CS-00228
(B)
CS-00761
CS-47
3) While pulling the cable (the slider is lowered),
adjust the length between the cable plate end and
the reverse check cable to 84 mm (3.31 in), and
tighten the locknut.
Tightening torque:
6 N·m (0.6 kgf-m, 4.4 ft-lb)
(A) 84 mm (3.31 in)
4) Move the transmission to the right side, and at-
tach the stay.
Tightening torque:
T:32 N·m (3.3 kgf-m, 23.6 ft-lb)
(A)
T
(A) Stay
CONTROL SYSTEMS
(A)
CS-00242
CS-00246