Subaru IMPREZA GD 2007 Series Manual page 3146

asieps_tobira_IM_US.book 17 ページ ２０１２年１月１７日 火曜日 午後３時４８分
3. CLEAR MEMORY MODE
1) On the «Main Menu» display screen, select {2.
Each System Check}.
2) Select {Brake Control} in the «Selection Menu»
screen.
3) Select [YES] after the information of engine type
is displayed.
4) On the «Brake Control Diagnosis» display
screen, select the {Clear Memory}.
Display Contents to be monitored
Clear memory? DTC deleting function
5) When the "Done" and "Turn Ignition Switch OFF"
are shown on the display screen, turn the ignition
switch to OFF, and terminate the Subaru Select
Monitor.
NOTE:
For details concerning the operation procedure, re-
fer to the "SUBARU SELECT MONITOR OPERA-
TION MANUAL".
4. ABS SEQUENCE CONTROL
Display Contents to be monitored
Operate the valve and
ABS
pump motor continuously
sequence
to perform the ABS
control
sequence control.
Subaru Select Monitor
5. FREEZE FRAME DATA
NOTE:
• Data stored at the time of trouble occurrence is
shown on the display.
• Each time a trouble occurs, the latest information
is stored in the freeze frame data in memory.
• Up to 3 freeze frame data will be stored.
• If a freeze frame data is not properly stored in
memory (due to a drop in ABSCM power supply,
etc.), a DTC suffixed with a question mark "?" ap-
pears on the Subaru Select Monitor display. This
shows it may be an unreliable reading.
Display
FR Wheel Speed
FL Wheel Speed
RR Wheel Speed
Index No.
RL Wheel Speed
<Ref. to ABS-
10, ABS
IG power supply
Sequence Con-
voltage
trol.>
G sensor output
voltage
Lateral G sensor
output voltage
Motor Relay
Monitor
Stop Light Switch Stop light switch signal
ABS operation
signal
Power Supply
Failure
Vehicle Speed
ABS(diag)-17
ABS (DIAGNOSTICS)
Contents to be monitored
Wheel speed detected by the front ABS
wheel speed sensor RH is displayed in
km/h or mile/h.
Wheel speed detected by the front ABS
wheel speed sensor LH is displayed in
km/h or mile/h.
Wheel speed detected by the rear ABS
wheel speed sensor RH is displayed in
km/h or mile/h.
Wheel speed detected by the rear ABS
wheel speed sensor LH is displayed in
km/h or mile/h.
Voltage supplied (V) to ABSCM&H/U is
displayed on the Subaru Select Monitor.
Voltage equivalent to vehicle accelera-
tion detected by analog G sensor is dis-
played.
Voltage equivalent to Lateral G detected
by analog Lateral G sensor is displayed.
Motor relay operation monitor signal
ABS operation signal
Whether abnormal voltage occurred or
not is displayed during malfunction.
Vehicle speed is displayed.