Subaru IMPREZA GD 2007 Series Manual page 2953

asieps_tobira_IM_US.book 48 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
14) Measure depth "Y" between the end of the ST
and the bearing cone.
ST 18831AA000 GAUGE
ST
Y
15) Using the following calculation, calculate the
transfer driven gear bearing thrust washer value t.
t = Z – (100 – Y) – {0.02 — 0.11 mm (0.0008 —
0.0043 in)}
t Transfer driven gear bearing thrust
mm (in) washer thickness
Y Depth between the end of the ST
mm (in) and the bearing cone.
Depth between the end of the
Z
extension case and the bearing
mm (in)
cone contact area.
Standard clearance between the
0.02 — 0.11 mm
thrust washer and taper roller bear-
(0.0008 — 0.0043 in)
ing
100 mm
Height of ST
(3.94 in)
Extension Case
16) Refer to the calculated value t to select the
closest thrust washer from the following table.
Standard clearance between the thrust washer
and taper roller bearing
0.02 — 0.11 mm (0.0008 — 0.0043 in)
NOTE:
Match to be within the standard clearance range.
Part No.
803050060
803050061
803050062
803050063
803050064
803050065
803050066
803050067
803050068
803050069
803050070
803050071
803050072
MT-00490
803050073
803050074
803050075
803050076
803050077
803050078
803050079
17) Install the selector arm No. 2 and the shifter
arm. (Transmission serial No. 144576 or earlier)
(A)
(A) Selector arm No. 2
(B) Shifter arm
6MT-48
Thrust washer (50 × 61 × t)
Thickness mm (in)
0.50 (0.0197)
0.55 (0.0217)
0.60 (0.0236)
0.65 (0.0256)
0.70 (0.0276)
0.75 (0.0295)
0.80 (0.0315)
0.85 (0.0335)
0.90 (0.0354)
0.95 (0.0374)
1.00 (0.0394)
1.05 (0.0413)
1.10 (0.0433)
1.15 (0.0453)
1.20 (0.0472)
1.25 (0.0492)
1.30 (0.0512)
1.35 (0.0531)
1.40 (0.0551)
1.45 (0.0571)
(B)
MT-01308