Subaru IMPREZA GD 2007 Series Manual page 2851

asieps_tobira_IM_US.book 28 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
B: INSTALLATION
1) Replace the differential side retainer oil seal.
<Ref. to 5MT-34, REPLACEMENT, Differential
Side Retainer Oil Seal.>
ST 18675AA000 DIFFERENTIAL SIDE OIL
SEAL INSTALLER
NOTE:
Be sure to replace the differential side retainer oil
seal after the removing the front drive shaft.
ST
2) Install the transmission cushion rubber to the
transmission assembly.
Tightening torque:
35 N·m (3.6 kgf-m, 26 ft-lb)
3) Install the transmission onto the engine.
(1) Lift up the transmission gradually using a
transmission jack.
(2) Engage at the spline section.
NOTE:
Be careful not to hit the main shaft against the
clutch cover.
4) Loosen the turnbuckle of the ST while raising the
transmission jack to return the engine to its original
position.
5) Install the front crossmember and rear cross-
member.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51.6 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
T 1
T 2
6) Take out the transmission jack.
Manual Transmission Assembly
7) Tighten the nuts which hold the lower side of
transmission to the engine.
Tightening torque:
50 N·m (5.1 kgf-m, 37 ft-lb)
8) Connect the transmission to the engine.
MT-00103
Tightening torque:
50 N·m (5.1 kgf-m, 37 ft-lb)
9) Remove the ST.
T 1
T 2
MT-00081
5MT-28
(1) Install the starter.
<Ref. to SC(H4SO)-8, INSTALLATION, Start-
er.>
(2) Tighten the bolts which hold the upper side
of the transmission to the engine.
ST
MT-00077
MT-01524
MT-01226