Subaru IMPREZA GD 2007 Series Manual page 2746

asieps_tobira_IM_US.book 13 ページ ２０１２年１月１７日 火曜日 午後３時４８分
C: CAUTION
• Wear appropriate work clothing, including a cap, protective goggles and protective shoes when performing
any work.
• Remove contamination including dirt and corrosion before removal, installation or disassembly.
• Keep the disassembled parts in order and protect them from dust and dirt.
• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, in-
stallation, disassembly and replacement.
• Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
• Use SUBARU genuine fluid, grease etc. or equivalent. Do not mix fluid, grease, etc. of different grades or
manufacturers.
• Be sure to tighten fasteners including bolts and nuts to the specified torque.
• Place shop jacks or rigid racks at the specified points.
• Apply grease onto sliding or revolving surfaces before installation.
• Before installing O-rings or snap rings, apply sufficient amount of fluid to avoid damage and deformation.
• Before securing a part in a vise, place cushioning material such as wood blocks, aluminum plate or cloth
between the part and the vise.
• Keep fluid away from the vehicle body. If any fluid contacts the vehicle body, immediately flush the area
with water.
D: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
ST-498497100
ST-499747100
2. GENERAL TOOL
TOOL NAME
Circuit tester
Dial gauge
Depth gauge
General Description
TOOL NUMBER DESCRIPTION
498497100 CRANKSHAFT
STOPPER
499747100 CLUTCH DISC
GUIDE
Used for measuring resistance, voltage and ampere.
Used for measuring clutch disc run-out.
Used for measuring clutch disc wear.
CL-13
CLUTCH SYSTEM
REMARKS
Used for stopping rotation of the flywheel when
loosening/tightening bolts, etc.
Used when installing the clutch disc to the fly-
wheel.
REMARKS