Subaru IMPREZA GD 2007 Series Manual page 2632

asieps_tobira_IM_US.book 125 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Reverse clutch retaining plate
Part No.
31567AA910
31567AA920
31567AA930
31567AA940
31567AA950
31567AA960
31567AA970
31567AA980
NOTE:
If the drive plate is not being replaced, do not ad-
just.
2. PLANETARY GEAR AND LOW CLUTCH
1) Install the D-ring to the low clutch piston.
2) Install the low clutch piston to low clutch drum.
(A) Low clutch piston
(B) Low clutch drum
3) Install the spring retainer to low clutch piston.
(A) Spring retainer
(B) Low clutch drum
AT Main Case
4) Attach the ST to the low clutch drum.
ST 498437100
Thickness mm (in)
4.0 (0.157)
4.2 (0.165)
4.4 (0.173)
4.6 (0.181)
4.8 (0.189)
5.0 (0.197)
5.2 (0.205)
5.4 (0.213)
5) Using ST1 and ST2, set the cover on the piston
and press against it, and attach the snap ring. At
this time, be careful not to bend the cover seal.
ST1 498627100
ST2 398673600
ST3 498437100
(A)
(B)
AT-00269
6) Install the dish plate, driven plate, drive plate and
retaining plate, and then secure them with a snap
ring.
(A)
(B)
AT-00270
7) Check the low clutch for operation.
4AT-125
AUTOMATIC TRANSMISSION
LOW CLUTCH PISTON
GUIDE
SEAT
COMPRESSOR
LOW CLUTCH PISTON
GUIDE
(A)
(B)
(A) Snap ring
(B) Low clutch drum
(C) Dish plate
(D) Low clutch piston side
(1) Remove the one-way clutch. <Ref. to 4AT-
108, REMOVAL, AT Main Case.>
ST
AT-00271
ST2
ST3
ST1
AT-00272
(C)
(D)
AT-02221