Subaru IMPREZA GD 2007 Series Manual page 2942

asieps_tobira_IM_US.book 37 ページ ２０１２年１月１７日 火曜日 午後３時４８分
8) Install the front crossmember and rear cross-
member.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51.6 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103 ft-lb)
T1
T2
9) Tighten the bolts which hold the upper side of
the transmission to the engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
10) Make sure that the release bearing is com-
pletely inserted.
NOTE:
• Push the release fork towards the operating cyl-
inder side until a clicking sound is heard. Pull the
release fork towards the engine side. If the release
fork is not in contact with the case, the setting is
complete.
• Confirm that the boot cover is set securely.
11) Install the pitching stopper bracket.
Tightening torque:
41 N·m (4.2 kgf-m, 30.2 ft-lb)
Manual Transmission Assembly
12) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
T1
T2
MT-00453
13) Install the throttle body. <Ref. to FU(H4DOTC)-
16, INSTALLATION, Throttle Body.>
14) Install the operating cylinder.
Tightening torque:
41 N·m (4.2 kgf-m, 30.2 ft-lb)
NOTE:
Check that the clutch hose is routed properly.
MT-01524
15) Install
SC(H4SO)-8, INSTALLATION, Starter.>
MT-00467
6MT-37
MANUAL TRANSMISSION AND DIFFERENTIAL
T2
the starter assembly.
T1
MT-00085
CL-00450
<Ref. to