Subaru IMPREZA GD 2007 Series Manual page 2767

asieps_tobira_IM_US.book 34 ページ ２０１２年１月１７日 火曜日 午後３時４８分
CLUTCH SYSTEM
11.Clutch Switch
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the instrument panel lower cover.
3) Disconnect the connector of clutch switch.
4) Remove the clutch switches.
B: INSTALLATION
1. CLUTCH SWITCH (CRUISE CONTROL)
1) Move the clevis pin of push rod to left and right,
retain it at the position where it moves smoothly,
and measure the clutch pedal stroke.
Clutch pedal full stroke A:
130 — 135 mm (5.12 — 5.31 in)
Tightening torque:
T: 8 N·m (0.8 kgf-m, 5.9 ft-lb)
2) If the clutch pedal stroke is out of specification,
adjust the stroke. <Ref. to CL-31, ADJUSTMENT,
Clutch Pedal.>
3) Connect the clutch switch connector.
2. CLUTCH SWITCH (STARTER INTERLOCK)
1) Fully depress the clutch and hold it.
2) Install the clutch pedal plate and clutch switch so
that the gap between them is 3 — 3.5 mm (0.12 —
0.14 in), and then tighten the lock nut.
Tightening torque:
8 N·m (0.8 kgf-m, 5.9 ft-lb)
(A)
(A) Plate
(B) Clutch switch
(C) 3 — 3.5 mm (0.12 — 0.14 in)
Clutch Switch
T
A
CL-00225
(C)
(B)
CL-00104
CL-34
3) Connect the clutch switch connector.
4) Make sure that engine does not start with clutch
pedal not depressed.
5) Make sure that engine starts with clutch pedal
fully depressed.
C: INSPECTION
1) If the clutch switch (cruise control) does not op-
erate properly (or if it does not stop at the specified
position), replace it with a new part.
Specified position L:
2 + 1.5 mm (0.079 + 0.059 in)
L
2) Check the clutch switch for continuity. If the re-
sistance is not at the standard value, replace the
switch.
(1) Disconnect the clutch switch connector.
(2) Measure the resistance between terminal 1
and 2 of the switch.
• Clutch switch (cruise control)
Condition Terminal No.
When clutch pedal is
No. 1 — No. 2:
depressed
When the clutch pedal
No. 1 — No. 2:
is not depressed.
2 1
CL-00231
Specified
resistance
1 MΩ or more
Less than 1 Ω
CL-00084