Subaru IMPREZA GD 2007 Series Manual page 3050

asieps_tobira_IM_US.book 15 ページ ２０１２年１月１７日 火曜日 午後３時４８分
6. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
1) Prepare the Subaru Select Monitor kit. <Ref. to
6MT(diag)-5, SPECIAL TOOL, PREPARATION
TOOL, General Description.>
2) Connect the diagnosis cable to the Subaru Se-
lect Monitor.
3) Connect the Subaru Select Monitor to the data
link connector.
(1) The data link connector is located in the low-
er portion of the instrument panel (on the driv-
er's side).
(1) Data link connector
(2) Connect the diagnosis cable to the data link
connector.
CAUTION:
Do not connect any scan tools except the Sub-
aru Select Monitor or general scan tool.
4) Turn the ignition switch to ON (engine OFF) and
run the Subaru Select Monitor.
5) On the «Main Menu» display screen, select {Each
System Check}.
6) On the «System Selection Menu» display screen,
select {Transmission}.
7) Select {Center Differential Control}.
8) On the «Transmission Diagnosis» display screen,
select {DTC Display}.
NOTE:
• For details concerning the operation procedure,
refer to the "SUBARU SELECT MONITOR OPER-
ATION MANUAL".
• For details concerning DTCs, refer to List of Di-
agnostic Trouble Code (DTC). <Ref. to 6MT(diag)-
26, List of Diagnostic Trouble Code (DTC).>
9) If the transmission and Subaru Select Monitor
cannot communicate, check the communication
circuit. <Ref. to 6MT(diag)-18, COMMUNICATION
FOR INITIALIZING IMPOSSIBLE, INSPECTION,
Subaru Select Monitor.>
Subaru Select Monitor
MANUAL TRANSMISSION AND DIFFERENTIAL (DIAGNOSTICS)
(1)
MT-01239
6MT(diag)-15
10) On the «Diagnostic Code(s) Display» screen,
select {Current Diagnostic Code(s)} or {History Di-
agnostic Code(s)}.
Display Contents to be monitored
The current DTC is displayed on Subaru
Latest code
Select Monitor display screen.
The current DTC is displayed on the
Memory code
Subaru Select Monitor display screen.