Subaru IMPREZA GD 2007 Series Manual page 3352

asieps_tobira_IM_US.book 28 ページ ２０１２年１月１７日 火曜日 午後３時４８分
DRIVE SHAFT SYSTEM
13) Install the rear ABS wheel speed sensor.
(1) ABS wheel speed sensor
14) Install the wheel and tighten the wheel nuts to
specified torque.
Tightening torque:
100 N·m (10.2 kgf-m, 73.8 ft-lb)
15) Make the tires completely touch the ground.
CAUTION:
Always tighten the stabilizer bushing in the
state where the vehicle is at curb weight and
the wheels are in full contact with the ground.
16) Tighten the rear housing assembly and lateral
link assembly installation bolts.
Tightening torque:
140 N·m (14.3 kgf-m, 103 ft-lb)
17) Tighten the rear housing assembly and trailing
link assembly installation bolts.
Tightening torque:
90 N·m (9.2 kgf-m, 66 ft-lb)
C: DISASSEMBLY
1) Using ST1 and ST2, remove the hub from the
rear housing.
ST1 927080000 HUB STAND
(Except for STI model)
ST1 28099PA080 HUB STAND (STI model)
ST2 927420000 HUB REMOVER
ST2
ST1
2) Remove the back plate from the rear housing
3) Remove the outer and inner oil seals using a flat
tip screwdriver.
Rear Axle
4) Remove the snap ring using a flat tip screwdriv-
er.
NOTE:
Be careful not to damage housing during removal.
( 1 )
DS-00069
5) Using ST1 and ST2, remove the bearing by
pressing the inner race.
ST1 927430000
ST1 28099PA060 HOUSING STAND
ST2 927440000
ST2 927100000
6) Remove the tone wheel bolts and remove the
tone wheel from the hub.
7) Using ST, press the hub bolt out.
ST 927080000
ST 28099PA080 HUB STAND (STI model)
CAUTION:
Be careful not to hammer the hub bolts. Doing
so may deform the hub.
DS-00088
DS-28
DS-00089
HOUSING STAND
(Except for STI model)
(STI model)
BEARING PULLER
(Except for STI model)
BEARING PULLER
(STI model)
ST2
ST1
DS-00090
HUB STAND
(Except for STI model)
ST
DS-00054