Subaru IMPREZA GD 2007 Series Manual page 2808

asieps_tobira_IM_US.book 35 ページ ２０１２年１月１７日 火曜日 午後３時４８分
B: INSTALLATION
1. 5MT
1) Install the joint to the transmission and secure
with a spring pin.
2) Insert the gear shift lever from the room side.
NOTE:
After inserting the rod and stay, temporarily posi-
tion them on the transmission mount.
3) Lift up the vehicle.
4) Install the joint to the shifter arm.
5) Insert the spring pin.
(B)
(A) Joint
(B) Spring pin
6) Mount the cushion rubber on the vehicle body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
(A)
(A) Stay
(B) Cushion rubber
MT Gear Shift Lever
CS-00054
(A)
CS-00053
(B)
CS-00052
CS-35
7) Connect the rod to the joint.
Tightening torque:
12 N·m (1.2 kgf-m, 8.9 ft-lb)
(A)
(A) Stay
(B) Rod
8) Connect the stay to the transmission bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
(A)
(B)
(A) Stay
(B) Transmission bracket
9) Install the rear exhaust pipe and muffler.
• SOHC model
<Ref. to EX(H4SO)-8, INSTALLATION, Rear Ex-
haust Pipe.> <Ref. to EX(H4SO)-9, INSTALLA-
TION, Muffler.>
• DOHC Turbo model
<Ref. to EX(H4DOTC)-15, INSTALLATION, Rear
Exhaust Pipe.> <Ref. to EX(H4DOTC)-17, IN-
STALLATION, Muffler.>
10) Lower the vehicle.
CONTROL SYSTEMS
(B)
CS-00051
CS-00050