asieps_tobira_IM_US.book 84 ページ 2012年1月17日 火曜日 午後3時48分
AUTOMATIC TRANSMISSION
D: ASSEMBLY
1) Press-fit the reduction drive gear to shaft.
2) Press-fit the new ball bearing into reduction drive
gear.
3) Apply ATF onto the seal ring outer surface and
shaft grooves.
4) Apply ATF to new seal rings, then install.
(A)
(B)
(A) Seal ring
(B) Reduction drive shaft
E: INSPECTION
• Rotate the bearing by hand, and make sure it ro-
tates smoothly.
• Check each part to make sure that there are no
holes, cuts, or attached dust.
• Inspect the extension end play, and adjust it to
the standard value. <Ref. to 4AT-77, ADJUST-
MENT, Transfer Clutch.>
Reduction Drive Gear
AT-00161
4AT-84