Subaru IMPREZA GD 2007 Series Manual page 3450

asieps_tobira_IM_US.book 44 ページ ２０１２年１月１７日 火曜日 午後３時４８分
POWER ASSISTED SYSTEM (POWER STEERING)
16) Apply a coat of grease on the gear teeth of the
valve assembly, and then attach the valve assem-
bly taking care not to scratch oil seal and seal ring.
(2)
(1) Seal ring
(2) Oil seal
17) Apply grease on the oil seal circumference, and
then press it into the plug using ST and a press. Re-
place the O-rings of plug circumference with new
O-rings.
ST 34199AE110 OIL SEAL PLUG INSTALLER
CAUTION:
Install the oil seal paying attention to correct di-
rection.
(1) Plug
(2) O-ring
(3) Oil seal
Steering Gearbox
18) Attach the plug using ST.
ST 34199AE090 PLUG WRENCH
Tightening torque:
64 N·m (6.5 kgf-m, 47.0 ft-lb)
(1)
PS-00658
(1) Plug
19) Install the dust cover. Remove the vinyl tape.
(1) Dust cover
20) Temporarily install the tie-rod to rack end, and
then operate the rack from lock to lock for two or
three times to make it fit in. Remove any grease
blocking the air vent hole.
PS-00087
CAUTION:
If operating the rack from lock to lock without
installing tie-rods, it may damage the oil seal.
Always install the tie-rods LH and RH.
PS-44
ST
(1)
PS-00659
(1)
PS-00781