Subaru IMPREZA GD 2007 Series Manual page 2961

asieps_tobira_IM_US.book 56 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
16.Transfer Driven Gear
A: REMOVAL
1) Remove the manual transmission assembly
from the vehicle. <Ref. to 6MT-34, REMOVAL,
Manual Transmission Assembly.>
2) Prepare the transmission for overhaul. <Ref. to
6MT-39, Preparation for Overhaul.>
3) Remove the extension case. <Ref. to 6MT-44,
REMOVAL, Extension Case.>
4) Remove the transfer driven gear.
B: INSTALLATION
1) Install the transfer driven gear.
2) When the bearing or the transfer driven gear is
replaced, select an appropriate thrust washer for
the transfer driven gear. <Ref. to 6MT-46, AD-
JUSTMENT, Extension Case.>
3) Install the extension case. <Ref. to 6MT-44, IN-
STALLATION, Extension Case.>
4) Install the manual transmission assembly to the
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
Transfer Driven Gear
C: DISASSEMBLY
1) Using the ST, remove the roller bearing (exten-
sion case side).
ST 498515700
ST
2) Using the ST, remove the roller bearing (trans-
mission case side).
ST1 899858600 REMOVER
ST2 899864100
MT-00951
ST1
D: ASSEMBLY
1) Using the ST, install the roller bearing (extension
case side).
ST1 398177700 INSTALLER
MT-00951
ST2 899864100
CAUTION:
Do not apply pressure in excess of 10 kN (1 ton,
1.1 US ton, 1.0 Imp ton).
(A) Roller bearing
6MT-56
REMOVER
MT-00511
REMOVER
ST2
MT-00512
REMOVER
ST2
(A)
ST1
MT-00513