Subaru IMPREZA GD 2007 Series Manual page 3360

asieps_tobira_IM_US.book 36 ページ ２０１２年１月１７日 火曜日 午後３時４８分
DRIVE SHAFT SYSTEM
19) Put a new band through the clip and wind twice
in the band groove of the boot.
20) Tighten the band using the ST.
ST 925091000 BAND TIGHTENING TOOL
NOTE:
Tighten the band until it cannot be moved by hand.
21) Tap the clip with the punch provided at the end
of the ST.
ST 925091000 BAND TIGHTENING TOOL
CAUTION:
Tap to an extent that the boot underneath is not
damaged.
22) Cut off the band with an allowance of about 10
mm (0.39 in) left from the clip and bend this allow-
ance over the clip.
CAUTION:
Make sure that the end of the band is in close
contact with clip.
23) Extend and retract the PTJ to provide equal
grease coating.
2. BJ+DOJ-TYPE
NOTE:
Use specified grease.
BJ side:
NTG2218-M (Part No. 28395AG030)
DOJ side:
NKG205 (Part No. 28495AG010)
1) Set BJ boot and small boot band on the BJ side
of shaft.
CAUTION:
Be sure to wrap shaft splines with vinyl tape to
protect the boot from scratches.
Front Drive Shaft
2) Set the drive shaft on a vise.
CAUTION:
Do not set the drive shaft on a vise directly. Be
sure to use wooden blocks.
3) Apply a thin coat of specified grease [60 to 70 g
(2.12 to 2.47 oz)] to the BJ.
4) Apply an even coat of the specified grease [20 to
30 g (0.71 to 1.06 oz)] to the entire inner surface of
boot. Also apply grease to the shaft.
NOTE:
The BJ installing surface of BJ boot shall be
cleaned completely so as to be free from grease
and other substances.
5) Attach the boot protrusion on the BJ groove.
DS-00132
(A) BJ
(B) Large boot band
(C) Boot
6) Set the large boot band in the specified position.
7) Attach the boot protrusion on the shaft groove.
DS-00133
(A) Boot
(B) Small boot band
(C) Shaft
DS-36
(B)
(C)
(A)
DS-00114
(A)
(B)
(C)
DS-00115