Subaru IMPREZA GD 2007 Series Manual page 3031

asieps_tobira_IM_US.book 126 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
30.Steering Angle Sensor
A: REPLACEMENT
CAUTION:
• Do not remove except when performing re-
placement.
• If the sensor needs replacement, replace
along with the combination switch assembly
once every three times for the protection of the
threaded portion.
1) Set the steering wheel to the straight-ahead po-
sition.
2) Disconnect the ground cable from battery.
3) Remove the airbag module.
<Ref. to AB-13, REMOVAL, Driver's Airbag Mod-
ule.>
WARNING:
Always refer to "Airbag System" when servic-
ing the airbag module.
<Ref. to AB-3, CAUTION, General Description.>
4) Remove the steering wheel.
<Ref. to PS-18, REMOVAL, Steering Wheel.>
5) Remove the screws, and remove the steering
column lower cover.
6) Remove the two screws holding the steering col-
umn upper cover.
7) Unlock the harness band lock, and disconnect
the steering angle sensor connector.
(1) Harness band
(2) Connector
8) Remove the screws holding the roll connector to
the steering column.
Steering Angle Sensor
9) Remove the steering angle sensor from the roll
connector.
10) Turn the protrusion portion of new steering an-
gle sensor to match the alignment mark of inspec-
tion hole.
(1) Protrusion
(2) Inspection hole
(3) Alignment mark
CAUTION:
Be careful not to allow any foreign objects to
enter the inspection hole.
11) Align the center of roll connector.
( 1 )
<Ref. to AB-19, INSTALLATION, Roll Connector.>
12) Apply the grease provided with the new part on
the 4 locations of the protrusion on the steering an-
( 2 )
gle sensor.
VDC00093
(1) Grease application location
VDC00422
6MT-126
VDC00208
(2)
(3)
VDC00209
ABS00435
(1)
(1)