Subaru IMPREZA GD 2007 Series Manual page 3007

asieps_tobira_IM_US.book 102 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
18) Install the center differential. <Ref. to 6MT-58,
INSTALLATION, Center Differential.>
19) Install the transfer driven gear. <Ref. to 6MT-
56, INSTALLATION, Transfer Driven Gear.>
20) Install the extension case. <Ref. to 6MT-44, IN-
STALLATION, Extension Case.>
21) Install the oil pipe, neutral position switch,
back-up light switch and harness. <Ref. to 6MT-41,
INSTALLATION, Oil Pipe.> <Ref. to 6MT-43, IN-
STALLATION, Neutral Position Switch.> <Ref. to
6MT-42, INSTALLATION, Back-up Light Switch.>
22) Install the manual transmission assembly to the
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
C: DISASSEMBLY
1. DIFFERENTIAL CASE
1) Fix the differential assembly on a vice, and re-
move the hypoid driven gear.
2) Remove the side bearing of the hypoid driven
gear using the ST.
ST 399527700 PULLER SET
ST
Front Differential Assembly
3) Use a flat tip screw driver to make a 2-3 mm
(0.079 — 0.118 in) clearance between the speed-
ometer drive gear and the roller bearing.
NOTE:
Be careful not to damage the differential case.
4) Using the ST, remove the roller bearing.
ST 498077000
MT-00660
2. DIFFERENTIAL SIDE RETAINER
1) Remove the O-rings on both sides of the differ-
ential side retainer.
MT-00663
6MT-102
(A)
(A) Speedometer drive gear
(B) Roller bearing
REMOVER
(B)
MT-00664
ST
MT-00665
MT-00666