Subaru IMPREZA GD 2007 Series Manual page 3451

asieps_tobira_IM_US.book 45 ページ ２０１２年１月１７日 火曜日 午後３時４８分
21) Apply a coat of grease to the sliding surface of
seat pad, sleeve and seating surface of spring, and
then insert sleeve into spring body.
Charge the adjusting screw with grease, and then
insert the spring into adjusting screw. Then install
on the steering body.
(1) Sheet pad
(2) Sleeve
(3) Spring
(4) Adjusting screw
(5) Lock nut
22) Tighten the adjusting screw to the specified
torque.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
23) Tighten to the specified torque, then loosen it
by 37°.
24) Remove the tie-rod.
25) Check that the play, or looseness, is within the
standard value. <Ref. to PS-48, SERVICE LIMIT,
INSPECTION, Steering Gearbox.>
26) Loosen the adjusting screw, and then apply liq-
uid gasket to at least 1/3 of the entire perimeter of
adjusting screw thread.
Liquid gasket
THREE BOND 1141 (Part No. 004403006)
(1)
(1) Apply liquid gasket to at least 1/3 of entire
perimeter.
Steering Gearbox
POWER ASSISTED SYSTEM (POWER STEERING)
27) Tighten the adjusting screw.
Tightening torque:
9.8 N·m (1.0 kgf-m, 7.2 ft-lb)
28) Tighten to the specified torque, then loosen it.
29) Tighten the adjusting screw.
Tightening torque:
4.8 N·m (0.49 kgf-m, 3.5 ft-lb)
30) Tighten to the specified torque, then loosen it.
31) Tighten the adjusting screw.
Tightening torque:
4.8 N·m (0.49 kgf-m, 3.5 ft-lb)
32) Tighten to the specified torque, then loosen it
by 37°.
33) Install the lock nut. While holding the adjusting
screw with a wrench, tighten the lock nut using ST.
PS-00090
ST 926230000
Tightening torque (lock nut):
40 N·m (4.1 kgf-m, 29.5 ft-lb)
NOTE:
Hold the adjusting screw with a wrench to prevent it
from turning while tightening the lock nut.
34) Install the tie-rod into rack.
Tightening torque:
90 N·m (9.0 kgf-m, 65.1 ft-lb)
NOTE:
Check the mating face of rack and tie-rod for for-
eign matter such as dust etc.
35) Apply a coat of grease to the tie-rod groove,
and then install the boot to the housing.
NOTE:
Make sure that the boot is installed without unusual
inflation or deflation.
PS-00660
PS-45
SPANNER
PS-00094