Subaru IMPREZA GD 2007 Series Manual page 2977

asieps_tobira_IM_US.book 72 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
3) Set the main shaft assembly to the ST, and re-
move the lock nut and washer.
ST1 18665AA000 HOLDER
ST2 18664AA000 BASE
NOTE:
Use a 38 mm socket wrench.
4) Remove the main shaft assembly from the ST.
5) Set the ST1 to the 6th drive gear, and use a
press to remove the taper roller bearing, bushing
and 6th drive gear.
ST1 18722AA010 REMOVER
ST2 899864100 REMOVER
ST1
ST1
(B)
(A) Taper roller bearing
(B) Bushing
(C) 6th drive gear
Main Shaft Assembly
ST2
ST1
MT-00556
ST2
(A)
(C)
MT-00557
6MT-72
6) Remove the 5th-6th sleeve, 6th needle bearing
and 6th baulk ring.
(A) Needle bearing
(B) 6th baulk ring
(C) 5th-6th sleeve
7) Set the ST to the 3rd drive gear, and use a press
to remove individual parts.
ST 18720AA000 REMOVER
(B)
ST
ST
(B)
(A) 3rd drive gear
(B) 3rd-4th sleeve
D: ASSEMBLY
NOTE:
Replace the following parts as a set.
• Sleeve and hub
• Outer baulk ring, 3rd synchro cone and inner
baulk ring
• Taper roller bearing
1) Apply adequate gear oil to the main shaft, 3rd
needle bearing and 3rd drive gear inner surface.
(A)
(B)
(C)
MT-00558
(A)
MT-00559