Subaru IMPREZA GD 2007 Series Manual page 2579

asieps_tobira_IM_US.book 72 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
4) Remove the transfer clutch pipe while being
careful not to deform the pipe.
5) Remove the dust cover from extension case.
6) Remove the oil seal from the extension case.
D: ASSEMBLY
1. MP-T MODEL
1) Press-fit the new oil seal using ST and the press.
ST 498057300 INSTALLER
2) Press-fit the dust cover.
3) Install the transfer clutch pipe to the extension
case while being careful not to deform the pipe.
(A) Extension case
(B) Transfer pipe
4) Install the transfer clutch assembly to the case.
NOTE:
• Be careful not to damage the seal ring.
• Press-fit the clutch assembly to the bottom of the
bearing shoulder completely.
(A)
(B)
(A) Transfer clutch
(B) Extension case
Extension Case
2. VTD MODEL
1) Press-fit the new oil seal using ST and the press.
ST 498057300
2) Press-fit the dust cover.
3) Install the transfer clutch pipe to the extension
case while being careful not to deform the pipe.
AT-00124
4) Apply ATF to a new O-ring and install the test
plug.
Tightening torque:
13 N·m (1.3 kgf-m, 9.6 ft-lb)
(A)
(B)
(A) Test plug
AT-00120
(B) Extension case
5) Insert the multiplate clutch, drive plate, driven
plate and spring retainer.
(A) Spring retainer
(B) Multi plate clutch piston ASSY
AT-00125
4AT-72
INSTALLER
AT-00124
(A)
(B)
AT-00122
(A)
(B)
AT-00126