Subaru IMPREZA GD 2007 Series Manual page 2589

asieps_tobira_IM_US.book 82 ページ ２０１２年１月１７日 火曜日 午後３時４８分
AUTOMATIC TRANSMISSION
2. VTD MODEL
1) Set the range select lever to the "P" range.
2) Use a plastic hammer to install reduction driven
gear assembly.
3) Use a plastic hammer to attach the center differ-
ential.
4) Attach a new lock nut and a new washer.
Tightening torque:
100 N·m (10.2 kgf-m, 73.8 ft-lb)
5) After tightening, stake the lock nut securely.
6) Insert the rear drive shaft assembly. <Ref. to
4AT-80, INSTALLATION, Rear Drive Shaft.>
7) Join the transmission case and the extension
case, and then install the rear vehicle speed sen-
sor. <Ref. to 4AT-70, INSTALLATION, Extension
Case.>
8) Install the transmission assembly to the vehicle.
<Ref. to 4AT-39, INSTALLATION, Automatic
Transmission Assembly.>
C: DISASSEMBLY
1) Remove the snap ring from reduction driven
gear.
(A)
(A) Snap ring
Reduction Driven Gear
2) Remove the ball bearing from reduction driven
gear using ST.
ST 498077600
(A) Ball bearing
3) Remove the gear inner groove snap ring from
the reduction driven gear.
D: ASSEMBLY
AT-00155
1) Install the snap ring to the gear inner grove on
the reduction driven gear.
2) Install the new ball bearing to reduction driven
gear using press.
(A) Ball bearing
3) Install the snap ring to reduction driven gear.
AT-00156
(A) Snap ring
E: INSPECTION
Make sure that the ball bearing and gear are not
deformed or damaged.
4AT-82
REMOVER
ST
(A)
(A)
(A)
AT-00157
AT-00158
AT-00156