asieps_tobira_IM_US.book 14 ページ 2012年1月17日 火曜日 午後3時48分
AUTOMATIC TRANSMISSION (DIAGNOSTICS)
6. Subaru Select Monitor
A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to the Subaru Select
Monitor.
3) Connect the Subaru Select Monitor to the data
link connector.
(1) Data link connector is located in the lower
portion of instrument panel (on the driver's side).
(2) Connect the diagnosis cable to the data link
connector.
NOTE:
Do not connect scan tools except for Subaru Select
Monitor.
4) Turn the ignition switch to ON (engine OFF) and
run the Subaru Select Monitor.
5) On the «Main Menu» display screen, select {Each
System Check}.
6) On the «System Selection Menu» display screen,
select {Transmission}.
7) Select the [OK] after the information of transmis-
sion type is displayed.
8) On the «Transmission Diagnosis» display screen,
select {DTC Display}.
NOTE:
• For details concerning the operation procedure,
refer to the «SUBARU SELECT MONITOR OPER-
ATION MANUAL».
• For details concerning the diagnostic trouble
codes (DTC), refer to the List of DTC. <Ref. to
4AT(D)(diag)-29, List of Diagnostic Trouble Code
(DTC).>
Subaru Select Monitor
2. READ CURRENT DATA
1) On the «Main Menu» display screen, select
{Each System Check}.
2) On the «System Selection Menu» display
screen, select {Transmission}.
3) Select the [OK] after the information of transmis-
sion type is displayed.
4) Select {Current Data Display & Save} in the
«Transmission Diagnosis» screen.
5) On the «Transmission Diagnosis» display
screen, select {Normal Measurement}.
AT-00422
4AT(D)(diag)-14