Subaru IMPREZA GD 2007 Series Manual page 3442

asieps_tobira_IM_US.book 36 ページ ２０１２年１月１７日 火曜日 午後３時４８分
POWER ASSISTED SYSTEM (POWER STEERING)
18) Tighten to the specified torque, then loosen it
by 25°.
19) Remove the tie-rod.
20) Check that the play, or looseness, is at the
standard value. <Ref. to PS-48, SERVICE LIMIT,
INSPECTION, Steering Gearbox.>
21) Loosen the adjusting screw, and then apply liq-
uid gasket to at least 1/3 of the entire perimeter of
adjusting screw thread.
Liquid gasket:
THREE BOND 1141 (Part No. 004403006)
(1) Apply liquid gasket to at least 1/3 of entire
perimeter.
22) Tighten the adjusting screw to the specified
torque.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
23) Tighten to the specified torque, then loosen it
by 25°.
24) Install the lock nut. While holding the adjusting
screw with a wrench, tighten the lock nut using ST.
ST 926230000 SPANNER
Tightening torque (lock nut):
40 N·m (4.1 kgf-m, 29.5 ft-lb)
NOTE:
Hold the adjusting screw with a wrench to prevent it
from turning while tightening the lock nut.
25) Extend the rack approx. 40 mm (1.57 in) from
steering body.
Steering Gearbox
26) Install the tie-rod and new lock washer into
rack.
Tightening torque:
78 N·m (8.0 kgf-m, 57.9 ft-lb)
(1) Lock washer
(2) Approx. 40 mm (1.57 in)
27) Bend the lock washer and crimp it.
CAUTION:
Be careful not to scratch the rack when crimp-
PS-00092
ing lock washer.
(1) Lock washer
PS-36
(2)
(1)
PS-00439
PS-00093