Subaru IMPREZA GD 2007 Series Manual page 2626

asieps_tobira_IM_US.book 119 ページ ２０１２年１月１７日 火曜日 午後３時４８分
4) Take out the rear planetary carrier, washer and
thrust needle bearing.
(A)
(A) Rear planetary carrier
(B) Low clutch drum
5) Take out the rear internal gear.
(A)
(A) Rear internal gear
(B) Low clutch drum
6) Remove the snap ring from low clutch drum.
(A)
(B)
(A) Snap ring
(B) Low clutch drum
AT Main Case
7) Compress the spring retainer and remove the
snap ring from the low clutch drum using ST1 and
ST2.
ST1 498627100
ST2 398673600
(B)
AT-00262
(A) Snap ring
(B) Low clutch drum
8) Remove the one-way clutch. <Ref. to 4AT-108,
REMOVAL, AT Main Case.>
9) Install the one-way clutch inner race to the low
clutch drum, and then apply compressed air to re-
move the low clutch piston.
(B)
AT-00263
(A) Apply compressed air.
(B) One-way clutch inner race
10) Remove the one-way clutch inner race.
11) Remove the one-way clutch after taking out the
snap ring.
AT-00264
(A) Snap ring
(B) Plate
(C) One-way clutch
4AT-119
AUTOMATIC TRANSMISSION
SEAT
COMPRESSOR
ST2
(A)
(A)
(B)
(C)
(A)
(B)
ST1
(B)
AT-00265
AT-00266
AT-00267