Subaru IMPREZA GD 2007 Series Manual page 2852

asieps_tobira_IM_US.book 29 ページ ２０１２年１月１７日 火曜日 午後３時４８分
10) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 37 ft-lb)
T2: 58 N·m (5.9 kgf-m, 43 ft-lb)
T2
11) Install the throttle body.
• Non-turbo model
<Ref. to FU(H4SO)-12, INSTALLATION, Throttle
Body.>
• Turbo model
<Ref. to FU(H4DOTC)-16, INSTALLATION, Throt-
tle Body.>
12) Lift up the vehicle.
13) Install the front drive shaft into the transmis-
sion.
ST 28399SA010 OIL SEAL PROTECTOR
ST
14) Insert the ball joints of the transverse link into
the lower part of housing, then tighten the installing
bolts.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
( A )
(A) Transverse link
(B) Ball joint
Manual Transmission Assembly
15) Attach the stabilizer link to the transverse link.
• Wagon model
Tightening torque:
30 N·m (3.1 kgf-m, 22 ft-lb)
T1
MT-00085
• Sedan model
Tightening torque:
45 N·m (4.6 kgf-m, 33 ft-lb)
16) Attach the gear shift rod and stay.
Tightening torque:
12 N·m (1.2 kgf-m, 8.9 ft-lb)
AT-00110
( B )
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
17) Install the propeller shaft. <Ref. to DS-16, IN-
MT-00086
STALLATION, Propeller Shaft.>
5MT-29
MANUAL TRANSMISSION AND DIFFERENTIAL
(1) Attach the gear shift rod to the transmission.
(A)
(B) (B)
(A) Stay
(B) Gear shift rod
(2) Attach the stay to the transmission.
MT-00806
MT-00076
MT-00089