Subaru IMPREZA GD 2007 Series Manual page 2822

asieps_tobira_IM_US.book 49 ページ ２０１２年１月１７日 火曜日 午後３時４８分
6) Move the transmission to the right side, and re-
move the stay bolts and reverse check cable.
NOTE:
If the transmission is not moved aside, the stay
bolts may contact the body and cause damage.
(A)
(B)
(A) Stay
(B) Stay bolt
7) While pulling the cable (the slider is lowered),
adjust the length between the cable plate end and
the reverse check cable to 84 mm (3.31 in), and
tighten the locknut.
Tightening torque:
6 N·m (0.6 kgf-m, 4.4 ft-lb)
(A) 84 mm (3.31 in)
8) Move the transmission to the right side, and at-
tach the stay.
Tightening torque:
T:32 N·m (3.3 kgf-m, 23.6 ft-lb)
(A)
T
(A) Stay
Reverse Check Cable
9) Install the crossmember. <Ref. to 6MT-32, IN-
STALLATION, Transmission Mounting System.>
10) Install the rear exhaust pipe and muffler. <Ref.
to EX(H4DOTC)-15, INSTALLATION, Rear Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-17, INSTAL-
LATION, Muffler.>
11) Attach the reverse check cable, washer and
snap pin to the reverse check lever.
NOTE:
Make sure to attach the snap pin in proper direc-
tion.
CS-00245
12) Install the under cover.
(A)
CS-00242
CS-00246
CS-49
CONTROL SYSTEMS
(D)
(A)
(B)
(A) Reverse check cable
(B) Washer
(C) Snap pin
(D) Front side
(C)
CS-00224