Subaru IMPREZA GD 2007 Series Manual page 2900

asieps_tobira_IM_US.book 77 ページ ２０１２年１月１７日 火曜日 午後３時４８分
C: INSPECTION
1) Move the reverse shifter rod toward the reverse
side. Check the clearance between the reverse
idler gear and the timing case wall surface.
If out of specification, select an appropriate reverse
shifter lever and adjust.
Clearance A:
6.0 — 7.5 mm (0.236 — 0.295 in)
A
2) After installing a suitable reverse shifter lever,
shift into neutral. Check the clearance between the
reverse idler gear and the timing case wall surface.
If out of specification, select the appropriate washer
and adjust.
Clearance:
0 — 0.5 mm (0 — 0.020 in)
3) Check the reverse idler gear and shaft for dam-
age. Replace if damaged.
Reverse Idler Gear
MANUAL TRANSMISSION AND DIFFERENTIAL
D: ADJUSTMENT
1) Select the appropriate reverse shifter lever from
the table below, and adjust until the clearance be-
tween the reverse idler gear and transmission case
wall is within specification.
Clearance A:
6.0 — 7.5 mm (0.236 — 0.295 in)
MT-00305
Part No.
32820AA070
32820AA080
32820AA090
2) Select an appropriate washer from the table be-
low, and adjust until the clearance between the re-
verse idler gear and transmission case wall is
within specification.
Clearance:
0 — 0.5 mm (0 — 0.020 in)
MT-00306
Part No.
803020151
803020152
803020153
803020154
803020155
5MT-77
A
MT-00305
Reverse shifter lever
Mark Remarks
7 Far from case wall
8 Standard
9 Closer to case wall
MT-00306
Washer
Thickness mm (in)
0.4 (0.016)
1.1 (0.043)
1.5 (0.059)
1.9 (0.075)
2.3 (0.091)