Subaru IMPREZA GD 2007 Series Manual page 2624

asieps_tobira_IM_US.book 117 ページ ２０１２年１月１７日 火曜日 午後３時４８分
31) Adjust the total end play. <Ref. to 4AT-94, AD-
JUSTMENT, Oil Pump Housing.>
32) Install the thrust needle bearing in the proper
direction.
(A)
(A) High clutch and reverse clutch ASSY
(B) Thrust needle bearing
(C) Upside
(D) Downside
(E) Outside
33) Install a new gasket along with the oil pump
housing assembly.
34) Install the converter case assembly to the
transmission case assembly. <Ref. to 4AT-88, IN-
STALLATION, Converter Case.>
35) Insert the inhibitor switch and transmission
connector to the stay.
(B)
(A) Transmission harness
(B) Inhibitor switch harness
36) Install the air breather hose. <Ref. to 4AT-67,
INSTALLATION, Air Breather Hose.>
37) Install the oil cooler pipe. <Ref. to 4AT-66, IN-
STALLATION, ATF Cooler Pipe and Hose.>
38) Install the oil charge pipe with O-ring. <Ref. to
4AT-68, INSTALLATION, Oil Charge Pipe.>
AT Main Case
(C)
(B)
(E)
(D)
AT-02220
(A)
AT-01351
4AT-117
AUTOMATIC TRANSMISSION
39) Insert the input shaft, and check the amount of
protrusion.
NOTE:
Turn the input shaft lightly by hand while inserting.
Normal protrusion amount A:
50 — 55 mm (1.97 — 2.17 in)
A
40) Install the torque converter clutch assembly.
<Ref. to 4AT-69, INSTALLATION, Torque Convert-
er Clutch Assembly.>
41) Install the transmission assembly to the vehi-
cle. <Ref. to 4AT-39, INSTALLATION, Automatic
Transmission Assembly.>
C: DISASSEMBLY
1. HIGH CLUTCH AND REVERSE CLUTCH
1) Remove the snap ring, and then take out the re-
taining plate, drive plate and driven plate.
(A)
(A) Snap ring
2) Remove the snap ring, and then take out the re-
taining plate, drive plate and driven plate.
(A)
(A) Snap ring
AT-02384
AT-00236
AT-00237