Subaru IMPREZA GD 2007 Series Manual page 3378

asieps_tobira_IM_US.book 8 ページ ２０１２年１月１７日 火曜日 午後３時４８分
FRONT SUSPENSION
2. CAMBER
INSPECTION
1) Place the front wheel on the turning radius
gauge. Make sure the ground contact surfaces of
the front and rear wheels are at the same height.
2) Set the adapter into the center of wheel, and
then set the wheel alignment gauge.
(1)
(2)
(1) Alignment gauge
(2) Turning radius gauge
(3) Adapter
3) Measure the camber angle in accordance with
the operation manual for wheel alignment gauge.
NOTE:
Refer to "SPECIFICATION" for the camber angle
values.
Front: <Ref. to FS-2, SPECIFICATION, General
Description.>
Rear: <Ref. to RS-2, SPECIFICATION, General
Description.>
FRONT CAMBER ADJUSTMENT
1) Loosen the two self-locking nuts located at the
front lower section of the strut.
NOTE:
When the adjusting bolt needs to be loosened or
tightened, hold its head with a wrench and turn the
self-locking nut.
Wheel Alignment
2) Turn the camber adjusting bolt so that the cam-
ber is set at specification.
NOTE:
Moving the adjusting bolt by one scale changes the
camber by approximately 0°10'.
(3)
FS-00213
FS-8
(1)
(4)
(5)
(6) (7)
(2)
(3)
(1) Strut
(2) Adjusting bolt
(3) Housing
(4) Outer
(5) Inner
(6) Camber is increased.
(7) Camber is decreased.
FS-00008