Subaru IMPREZA GD 2007 Series Manual page 2997

asieps_tobira_IM_US.book 92 ページ ２０１２年１月１７日 火曜日 午後３時４８分
MANUAL TRANSMISSION AND DIFFERENTIAL
7) Attach the shifting insert key to the appropriate
location of the reverse sleeve.
NOTE:
The angle of each shifting insert key is 120°.
(A)
(A) Reverse sleeve
(B) Shifting insert key
8) Attach the reverse sleeve to the reverse idler
gear No. 2.
NOTE:
Confirm that the reverse sleeve is installed in the
proper direction.
9) Apply adequate gear oil to the collar, needle
bearing and reverse drive gear inner surface.
Reverse Idler Gear Assembly
(B)
(A)
(B)
MT-00633
MT-00634
6MT-92
10) Install the outer baulk ring, reverse synchro
cone and inner baulk ring.
(A)
(A) Outer baulk ring
(B) Reverse synchro cone
(C) Inner baulk ring
11) Install the collar and needle bearing, then the
knock pin.
(A) Collar
(B) Needle bearing
(C) Knock pin
12) Match the protrusion of the reverse synchro
cone to the hole on the reverse idler gear, and in-
stall the reverse idler gear.
(A)
(B)
(A) Protrusion on the reverse synchro cone
(B) Hole of the reverse idler gear
13) Point the groove towards the reverse idler gear,
and attach the washer.
(B)
(C)
MT-00635
(C)
(B)
(A)
MT-00636
MT-01508