Subaru IMPREZA GD 2007 Series Manual page 2858

asieps_tobira_IM_US.book 35 ページ ２０１２年１月１７日 火曜日 午後３時４８分
7. Switches and Harness
A: REMOVAL
1. BACK-UP LIGHT SWITCH AND
NEUTRAL POSITION SWITCH
1) Disconnect the ground cable from battery.
2) Remove the air intake duct and air cleaner case.
(Non-turbo model) <Ref. to IN(H4SO)-5, REMOV-
AL, Air Cleaner Case.> <Ref. to IN(H4SO)-7, RE-
MOVAL, Air Intake Duct.>
3) Remove the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-13, REMOVAL, Intercooler.>
4) Disconnect the connector back-up light switch
and neutral position switch.
• Non-turbo model
(B)
(A) Neutral position switch (Brown)
(B) Back-up light switch (Gray)
• Turbo model
5) Lift up the vehicle.
Switches and Harness
6) Remove the back-up light switch and neutral po-
sition switch along with the harness.
B: INSTALLATION
1. BACK-UP LIGHT SWITCH AND
(A)
NEUTRAL POSITION SWITCH
1) Install the back-up light switch and neutral posi-
tion switch with the harness.
Tightening torque:
MT-00104
2) Connect the connectors of the back-up light
switch and neutral position switch.
MT-00105
3) Install the air intake duct and air cleaner case.
(Non-turbo model) <Ref. to IN(H4SO)-5, INSTAL-
LATION, Air Cleaner Case.> <Ref. to IN(H4SO)-7,
INSTALLATION, Air Intake Duct.>
4) Install the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-14, INSTALLATION, Inter-
cooler.>
5) Connect the ground cable to battery.
5MT-35
MANUAL TRANSMISSION AND DIFFERENTIAL
(B)
(A) Neutral position switch (Brown)
(B) Back-up light switch (Gray)
32.3 N·m (3.3 kgf-m, 23.8 ft-lb)
(B)
(A) Neutral position switch
(B) Back-up light switch
(A)
MT-00106
(A)
MT-00106