Subaru IMPREZA GD 2007 Series Manual page 3262

asieps_tobira_IM_US.book 53 ページ ２０１２年１月１７日 火曜日 午後３時４８分
3) Remove the clutch master cylinder bracket.
4) Remove the bushing, spring and stopper.
(1) Stopper
(2) Bushing
(3) Brake pedal
(4) Brake pedal spring
5) Remove the brake pedal pad.
2. AT MODEL
1) Remove the brake switch.
2) Unbolt, and then remove the brake pedal.
Brake Pedal
3) Remove the bushing, spacer spring.
BR-00129
(1) Plug
(2) Stopper
(3) Brake pedal
(4) Brake pedal spring
4) Remove the brake pedal pad.
D: ASSEMBLY
1) Position the stop light switch, etc. to the brake
pedal.
2) Clean the inside of bores of the clutch pedal and
BR-00130
brake pedal, apply grease, and set bushings into
the bores.
3) Align bores of the pedal bracket, clutch pedal
and brake pedal, attach brake pedal return spring,
then install the pedal bolt.
NOTE:
Clean up the inside of bushings and apply a thin
coat of grease before installing the spacer.
Tightening torque:
T: 30 N·m (3.1 kgf-m, 22.1 ft-lb)
T
BR-00100
4) After attaching the brake pedal to the vehicle,
adjust the position of the stop light switch.
BR-53
BRAKE
BR-00101
BR-00102